9/7/2023 0 Comments Diy black lamp(If you haven’t touched up the seams well, you’ll have a little bit of light leakage through there as well.) It actually doesn’t make it through the 2 layers of black paint, but it creates some really pretty dramatic light by showing through only the top and bottom parts of the lamp.Someone else was curious about how the light came through the shade.It really seems to have not been a problem at all for ours. My perspective is that paint fumes don’t ever stay around too long.I had some people ask me if the paint was smelly when the lamp was turned on.This helps make sure it’s not leaning against anything when it dries! For ease of drying you can set the shade back on the lamp stand.This also helps bring out some of the 1st layer shine again. Wait about 1 hour and then hit any newly risen bumpy fibers with your 400 grit sand paper again.Make sure to smooth down any goopy bits to keep the finished project looking smooth and neat. Make sure to do even brush strokes the full height up and down of the shade, and pay special attention to the seams and along the top and bottom.It’s about the consistency of a creamy shoe polish. Apply your Versatex screen printing ink with the sponge applicator (or a brush you don’t care about).(This is where you’ll want a protected work space – drop cloth- so all the fibers and dust don’t end up all over your floor!) Make sure it feels nice and smooth to the touch. Use the 400 grit sandpaper to knock off the fibers.Once that dries, you’ll notice that some of the fibers of the shade come to the surface.Your first step is to do a light coat of spray paint over the whole shade, both inside and outside.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |